Caliper is an information, drafting and visualisation assistant. Its checklists, failure-mode reasoning, diagrams, clips and report drafts are reference material generated by AI to support your own work. They are drafts, not decisions.

Caliper is not a certified inspection, testing or verification service. It does not replace a qualified or chartered engineer, a statutory/legal inspection, NDT-certified personnel, or manufacturer official documentation.

• equipment acceptance, commissioning or release to service;
• pressure, load-bearing, structural, lifting or fitness-for-service safety sign-off;
• incident/failure determination, insurance or legal evidence;
• regulatory or standards compliance certification.

Any standard, clause or specification referenced is general guidance and may not reflect the current published edition. You must verify everything against the official current standard and your own site procedures before acting.

For any safety-critical scenario — pressure equipment, lifting, electrical, work at height, confined spaces, hazardous substances or rotating machinery — a suitably qualified and authorised person must assess the situation on site and remains fully responsible for the decision.

We do not warrant that output is accurate, complete or fit for any purpose, and the platform is not used for automated safety decisions. All decisions and their consequences remain the responsibility of you and your organisation. See the Terms of Service and Acceptable Use Policy.

Contact support@mechinsp.shop.